Need help?Do you have a question about the Art PRO MPA II and is the answer not in the manual?
General| Channels | 2 |
|---|---|
| Output Impedance | 600 Ohms |
| THD | <0.1% (typical) |
| Signal to Noise Ratio | >90dB |
| Maximum Input Level | +20dBu |
| Dynamic Range | >100dB |
| Gain | 70dB |
| Tubes | 2 x 12AX7 |
| Input Connectors | XLR |
| Output Connectors | XLR, 1/4" TRS |
| Phantom Power | +48V |
| Input Impedance | 1M Ohms |
| EIN | -129dBu (A weighted) |
| Power Supply | 50-60Hz |
| Dimensions | 483mm x 44.5mm |
| Maximum Output Level | +28dBu (Balanced/Unbalanced) |
Key safety guidelines covering voltage, ventilation, moisture, heat, handling, and servicing.
Details on low noise, high performance, variable impedance, tube circuit, VU meters, and mic/stereo support.
Optimizing input level, impedance for voicing, and low-cut filtering for microphone signals.
Controls for phantom power, phase, plate voltage, and Mid/Side matrix for channel functionality.
Adjusting output level, stereo/dual modes, and rear panel output level selection.
Dedicated ¼" jack for instrument signals with high impedance and auto-switching functionality.
Details on XLR balanced inputs and ¼" / cannon balanced outputs, including pinouts and impedance.
Procedure to set input gain and output level for best dynamic range and low noise.
How to use the impedance control to fine-tune microphone response and interaction with the pre-amp.
Selecting tube bias for sound characteristics and setting up Mid/Side stereo recording.
Covers the 3-year warranty period, what is covered, and exclusions like misuse.
Guidance on how to get the unit serviced, including website contact and packaging instructions.
Detailed specs including frequency response, dynamic range, THD, input/output levels, impedance, and gain.
To Next Page
