Need help?Do you have a question about the Art Pro VLA and is the answer not in the manual?
Power| power | 100-125VAC, 25W (USA) |
|---|---|
| output power | Internally fused |
| power configuration | configured for country of destination |
Input/Output Specifications| input/output connections | balanced XLR & 1/4” TRS |
|---|---|
| input impedance | XLR, 1/4” 20K ohms, 1M ohms |
| output impedance | XLR, 1/4” 600 ohm, 300 ohms |
Performance| frequency response | 10Hz to 20kHz (+/- .5dB) |
|---|---|
| dynamic range | >100dB (20-20kHz) |
| total harmonic distortion | <0.1% (typical) |
Weight and Dimensions| dimensions | 19”W X 6.5”D X 3.5”H |
|---|---|
| weight | 9.0 lbs |
Details the internal power supply, voltage requirements, and caution regarding power cable modifications.
Explains balanced XLR and 1/4" TRS connections, and the use of unbalanced cables.
Provides guidance on integrating the PRO VLA into various audio setups and rack mounting.
Explains how to set the threshold point for compressor action and how the Threshold LED indicates signal level.
Details how the ratio control determines the amount of compression applied once the signal exceeds the threshold.
Explains how to set the output gain (make-up gain) and how to use the bypass switch for proper level setting.
To Next Page
