Need help?Do you have a question about the Art TPS and is the answer not in the manual?
Power| power requirements USA | 110-125V AC / 50hz / 16W |
|---|---|
| power requirements Export units | configured for country of destination |
Audio Specifications| input impedance XLR | 5K ohms |
|---|---|
| input impedance ¼" | 1M ohm |
| output impedance XLR | 300 ohms |
| output impedance ¼" | 150 ohms |
| maximum input level XLR | +19dBu |
| maximum input level ¼" | +22dBu |
| maximum output level XLR | +28dBu |
| maximum output level ¼" | +22dBu |
| CMRR | >75dB (typical @ 1kHz) |
| frequency response | 5Hz to 50kHz, +/- .1dB |
| dynamic range | >100dB |
| total harmonic distortion (THD) clean | <0.01% |
| total harmonic distortion (THD) warm | <0.1% |
| maximum gain XLR to XLR | 80dB |
| maximum gain ¼" to ¼" | 68dB |
| maximum gain XLR to ¼" | 74dB |
| maximum gain ¼" to XLR | 74dB |
| equivalent input noise (EIN) XLR to XLR | -129dBu (A weighted) |
| equivalent input noise (EIN) ¼" to ¼" | -105dBu (A weighted) |
Tube Specifications| tube type | 12AX7A |
|---|---|
| tube characteristics | Dual Triode, Hand Selected |
Weight and Dimensions| height | 1.75 inches |
|---|---|
| width | 19 inches |
| depth | 6.5 inches |
| weight | 5.5 lbs |
Details the unit's internal power supply for operation at 115 VAC.
Explains balanced XLR and unbalanced 1/4" audio connection types.
Warns about electrical shock, moisture, and user-serviceable parts.
Sets the input gain, controlling two ranges (+20 to +68dB, +0 to +48dB).
Adds 20dB gain for microphone applications or hot line inputs.
Powers microphones needing +48 volts DC via the XLR input jack.
Reverses the phase of the signal on XLR and 1/4" output jacks.
Provides optimized reference points for recording various instruments.
Provides an analog representation of the tube signal level.
Sets the output level of the TPSTM unit.
Front panel jacks act as balanced XLR and unbalanced 1/4" inputs.
Rear XLR jacks function identically to the front ones.
Rear XLR outputs are active balanced for signal output.
Rear 1/4" jacks are unbalanced for sending signals to amps.
Lists V3 settings for neutral and warm voicings with and without OPL.
Guidance on using V3 presets as starting points for recording.
Details warranty terms: free from defects for three years from purchase.
Lists conditions that void the warranty, such as misuse or alterations.
Steps for unit service: troubleshooting, contact, packing, and shipping.
To Next Page
