TPS SPECIFICATIONS
Dimensions 1.75" H x 19" W x 6.5" D
Weight 5.5 lbs.
Input Connections Front: XLR (balanced)
Rear: Switchable XLR (bal.)/ ¼" TS
Output Connections XLR (balanced), ¼" TS
Input Impedance XLR, ¼" 5K ohms, 1M ohm
Output Impedance XLR, ¼" 300 ohms, 150ohms
Maximum Input Level, XLR +19dBu
Maximum Input Level, ¼" +22dBu
Maximum Output Level, XLR +28dBu
Maximum Output Level, ¼" +22dBu
CMRR >75dB (typical @ 1kHz)
Frequency Response 5Hz to 50kHz, +/-.1dB
Dynamic Range >100dB
Total Harmonic Distortion (THD) <0.01% (clean), <0.1%(warm)
Maximum Gain
XLR to XLR 80dB
¼" to ¼" 68dB
XLR to ¼" 74dB
¼" to XLR 74dB
Equivalent Input Noise (EIN)
XLR to XLR -129dBu (A weighted)
¼" to ¼" -105dBu (A weighted)
Tube Type 12AX7A, Dual Triode, Hand Selected
Power Requirements USA – 110-125V AC / 50hz/16W - Export
units configured for country of destination.
ART maintains a policy of constant product improvement. ART reserves the right to
make changes in design or make additions to or improvements upon this product
without any obligation to install same on products previously manufactured. Therefore,
specifications are subject to change without notice.
Applied Research & Technology
215 Tremont Street
Rochester, NY 14608 USA
(716) 436-2720
(716) 436-3942 (FAX)
www.artproaudio.com
© 2001 Applied Research & Technology
To Previous Page
Loading...
