8 Aruba 330 Series Access Points | Installation Guide
Figure 8 Mounting the Access Point
7. On the AP-334 and IAP-334, install the external antennas according to the manufacturer’s instructions, and
connect the antennas to the antenna interfaces on the access point.
Connecting Required Cables
Install cables in accordance with all applicable local and national regulations and practices.
Software
The AP-334 and AP-335 access points require ArubaOS 6.5.0.0 or higher. For additional information, refer to the
ArubaOS User Guide and ArubaOS Quick Start Guide. The IAP-334 and IAP-335 access points require Instant 4.3.0.0
or higher. For additional information, refer to the Aruba Instant User Guide and Aruba Instant Quick Start Guide.
Verifying Post-Installation Connectivity
The integrated LED on the access point can be used to verify that the access point access point is receiving power
and initializing successfully (see Table 1 and Table 2). Refer to the ArubaOS Quick Start Guide for further details on
verifying post-installation network connectivity.
Configuring the 330 Series
Access Point Provisioning/Reprovisioning
Provisioning parameters are unique to each access point. These local access point parameters are initially
configured on the controller and are then pushed out on the access points and stored on the devices. Aruba
recommends that provisioning settings be configured via the ArubaOS Web UI only. Refer to the ArubaOS User
Guide for complete details.
Access Point Configuration
Configuration parameters are network or controller specific and are configured and stored on the controller.
Network configuration settings are pushed out to the access points, but remain stored on the controller.
Configuration settings can be configuration via the ArubaOS Web UI or ArubaOS CLI. Refer to their respective
guides for further details: the ArubaOS User Guide.
Aruba access points are classified as radio transmission devices, and are subject to government regulations of
the host country. The network administrator(s) is/are responsible for ensuring that configuration and operation
of this equipment is in compliance with their country’s regulations. For a complete list of approved channels in
your country, refer to the Aruba Downloadable Regulatory Table at arubanetworks.com.
The instructions for this section are applicable to the AP-334 and AP-335 only.
To Next Page
Loading...
