Need help?Do you have a question about the Aruba CX 10000 Series and is the answer not in the manual?
General| Form Factor | 1U |
|---|---|
| Input Voltage | 100-240V AC |
| Operating Temperature | 0°C to 45°C |
| Operating Humidity | 5% to 95% non-condensing |
| Power Supply | Redundant hot-swappable power supplies |
| Management | CLI |
| Latency | < 1.5µs |
| Fans | Hot-swappable |
| Dimensions | 44 x 43.8 x 4.39 cm |
| Switching Capacity | Up to 25.6 Tbps |
Lists the supported Aruba CX 10000 switch models and accessories.
Lists other relevant documentation for the Aruba CX 10000 switches.
Provides a high-level introduction to the Aruba CX 10000 Distributed Services Switch.
Details the components and ports located on the front panel of the switch.
Describes the various network ports available on the switch, including QSFP28 and SFP28.
Explains the meaning of various LED indicators on the switch for status monitoring.
Highlights the key features and capabilities of the Aruba CX 10000 switch.
Lists the components included in the switch package.
Offers essential safety and installation advice to prevent damage or injury.
Provides instructions for properly grounding the switch for safety and compliance.
Outlines requirements and considerations for preparing the installation location.
Describes the procedures and options for physically mounting the switch in a rack.
Details methods for performing the initial configuration of the switch.
Guides users on connecting to the switch's console port for initial setup.
Details the pinout configuration for the RJ-45 to DB-9 console cable.
Provides step-by-step instructions for replacing a power supply unit.
Explains how to remove and install a fan tray for maintenance.
Offers general advice and common solutions for resolving switch issues.
Explains how to interpret LED patterns for diagnosing switch problems.
Describes methods for performing hardware-level diagnostic tests on the switch.
Details electrical specifications, including voltage and frequency requirements.
Provides information on the switch's power consumption under different operating conditions.
Lists operating and non-operating environmental parameters like temperature and humidity.
Specifies the types of cables and their standards suitable for the switch.
Outlines the supported distances for various network technologies and cables.
Provides contact information and methods for obtaining technical support.
Directs users to the Aruba Support Portal for downloads, documentation, and updates.
To Next Page
