Need help?Do you have a question about the Aruba 2930F 24G 4SFP and is the answer not in the manual?
General| Model | JL253A |
|---|---|
| Switching Capacity | 128 Gbps |
| Forwarding Rate | 95.2 Mpps |
| Layer | Layer 3 |
| PoE Support | No |
| Ports | 24 x 10/100/1000BASE-T |
| Uplink Ports | 4 x SFP |
| Power Supply | Internal power supply |
| Management | Web GUI, CLI, SNMP, RMON |
| Jumbo Frame Support | Yes, up to 9220 bytes |
| Dimensions | 44.25 x 24.61 x 4.44 cm |
| Operating Temperature | 0°C to 45°C (32°F to 113°F) |
| Operating Humidity | 15% to 95% non-condensing |
Step-by-step instructions for installing the switch.
Instructions for mounting the switch in a standard 19-inch rack or cabinet.
Specific mounting instructions for the Aruba 2930F 8G PoE+ 2SFP+ Switch model.
Steps to connect the switch to an electrical power source.
Guide for connecting network cables to the switch's RJ-45 and transceiver ports.
Essential initial settings for managing the switch, including IP and password.
Methods for accessing and managing the switch over the network.
General advice and common issues to check first when troubleshooting problems.
Using LED status indicators to identify and diagnose switch problems.
Procedures for performing hardware-level diagnostic tests on the switch.
Steps to reset the switch to its original factory default settings.
Requirements for twisted-pair and twinaxial copper cables.
How to contact Hewlett Packard Enterprise for technical assistance and documentation.
To Next Page
