Need help?Do you have a question about the Aruba 2540 and is the answer not in the manual?
General| Model | Aruba 2540 |
|---|---|
| Layer | Layer 2 and Layer 3 |
| MAC address table size | 16, 000 entries |
| Input Voltage | 100 - 240 VAC |
| Power Supply | Internal |
| Ports | 24 or 48 10/100/1000 ports |
| Uplink Ports | 4 x SFP+ |
| Switching Capacity | 176 Gbps for 48-port models |
| Forwarding Rate | 130.9 Mpps (48-port models) |
| Power over Ethernet (PoE) | PoE+ |
| Management | Web GUI, CLI, SNMP |
| Stacking | Virtual Stacking supported |
| Jumbo Frame Support | Yes |
| Memory | 512 MB RAM |
| Operating Temperature | 0°C to 45°C (32°F to 113°F) |
| Operating Humidity | 15% to 95% non-condensing |
Essential safety guidelines and warnings for switch installation to prevent damage or injury.
Steps and checks required before commencing the physical installation of the switch.
Specific instructions for mounting the switch using a two-post rack system.
Procedure for placing the switch on a secure horizontal surface using self-adhesive pads.
Crucial information and best practices for installing and using SFP/SFP+ transceivers.
Information on obtaining and installing the latest supported software version for the switch.
Details about approved power cords for the Aruba 2540 switch.
Comprehensive safety, environmental, and regulatory details for the Aruba 2540 switch series.
Specific compliance statements for Japan, Korea, and EAC regions, including EMC and VCCI.
Instructions on how to provide feedback to improve the product documentation.
To Next Page
