Need help?Do you have a question about the Aruba JL262A and is the answer not in the manual?
General| Product Number | JL262A |
|---|---|
| Product Series | Aruba 2930F |
| Device Type | Managed Switch |
| Switching Capacity | 176 Gbps |
| Rack Mountable | Yes |
| Layer | Layer 3 |
| Jumbo Frame Support | Yes |
| Uplink Ports | 4 x SFP |
| Input Voltage | 100-240VAC |
| Memory and Processor | 512 MB RAM, 32 MB Flash |
| Operating Temperature | 0°C to 45°C (32°F to 113°F) |
| Operating Humidity | 15% to 95% non-condensing |
| Management | CLI, SNMP |
| Warranty | Limited Lifetime |
Information on RJ-45 and Micro USB console ports for switch management.
Describes how to use the reset and clear buttons for system operations like reboots.
Safety and environmental guidelines to follow before and during switch installation.
Steps for basic setup, including IP address, subnet mask, and manager password.
Guide to interpreting LED patterns for diagnosing switch problems.
Procedure to reset the switch to its original factory configuration.
To Next Page
