What to do if the Aruba Switch link light does not light when a cable is connected?
If the link light on your Aruba Switch doesn't illuminate after connecting a cable, begin by checking for loose or visibly damaged connections. Ensure all connections are secure. If the issue persists, try using a different cable.
General| Model | JL682A |
|---|---|
| Category | Switch |
| Switching Capacity | 176 Gbps |
| Input Voltage | 100 - 240 VAC |
| Uplink Ports | 4 x 1G/10G SFP Ports |
| PoE Support | Yes, PoE+ |
| PoE Budget | 370W |
| Power Supply | Internal |
| Operating Temperature | 0°C to 45°C (32°F to 113°F) |
| Operating Humidity | 15% to 95% non-condensing |
Details the physical components and ports of the Aruba Instant On 1930 switches.
Explains the Power over Ethernet functionality and power delivery capabilities of the switches.
Describes how to use the reset button for troubleshooting and factory resets.
Advises on essential safety information and documentation to review before installation.
Provides crucial warnings and guidelines to prevent injury or damage during installation.
Provides instructions for physically installing the switch in various locations.
Details connecting the switch to a power source.
Guides on connecting network devices to the switch ports.
Covers installing, removing, and connecting cables to SFP transceivers.
Accessing and configuring the switch via a web browser.
Explains how to use LEDs for troubleshooting switch problems.
Provides steps to restore the switch to its original factory settings.
To Next Page
