What to do if the Aruba JL686A link light does not light when a cable is connected?
If the link light on your Aruba Switch doesn't illuminate after connecting a cable, begin by checking for loose or visibly damaged connections. Ensure all connections are secure. If the issue persists, try using a different cable.
General| Product Number | JL686A |
|---|---|
| Product Series | Aruba 2930F |
| Device Type | Switch |
| Uplink Ports | 4 x 1G SFP |
| Power over Ethernet (PoE) | Yes |
| PoE Budget | 370W |
| Switching Capacity | 176 Gbps |
| Input Voltage | 100-240VAC |
| Stackable | No |
| VLAN Support | Yes |
| IPv6 Support | Yes |
| Operating Humidity | 10% to 90% non-condensing |
| Weight | 5.4 kg |
| Memory and Processor | 512 MB RAM |
| Management | Web GUI, CLI, SNMP |
| Layer | Layer 3 |
| MAC Address Table Size | 16000 |
| Jumbo Frame Support | Yes |
| Operating Temperature | 0°C to 45°C |
Explains the Power Over Ethernet (PoE) functionality and power delivery capabilities of the switches.
Details how PoE power is allocated and managed across different 1930 switch models.
Provides essential safety advice before installing the Aruba Instant On 1930 switch.
Outlines critical precautions and guidelines to prevent injury or product damage during installation.
Summarizes the step-by-step process for installing the Aruba Instant On 1930 switch.
Provides instructions on various methods for physically mounting the Aruba Instant On 1930 switch.
Details the process of connecting the switch to an AC or DC power source for operation.
Explains how to connect network cables to the switch's RJ-45 ports or SFP transceivers.
Explains how to interpret LED status indicators for diagnosing switch problems.
Guides users on how to reset the switch to its original factory default configuration.
To Next Page
