What to do if the Aruba JL685A Switch link light does not light when a cable is connected?
If the link light on your Aruba Switch doesn't illuminate after connecting a cable, begin by checking for loose or visibly damaged connections. Ensure all connections are secure. If the issue persists, try using a different cable.
General| Product Number | JL685A |
|---|---|
| Device Type | Switch |
| Power over Ethernet (PoE) | Yes |
| PoE Power Budget | 370W |
| Switching Capacity | 176 Gbps |
| Layer | Layer 2+ |
| Input Voltage | 100-240V AC |
| Frequency | 50/60 Hz |
| Forwarding Rate | 130.9 Mpps |
| Memory | 512 MB |
| Jumbo Frame Support | Yes |
| Management | Web GUI, CLI, SNMP |
| Operating Temperature | 0°C to 45°C |
| Operating Humidity | 10% to 90% (non-condensing) |
| Power Supply | Internal |
| Ports | 48 x 10/100/1000BASE-T, 4 x 10G SFP+ |
Explains the Power over Ethernet functionality and power delivery capabilities of the switches.
Important safety information to review before installing the switch.
Precautions and guidelines to prevent injury or product damage during installation.
Steps to ensure the installation environment is ready for the switch.
Specifies the necessary clearance for proper switch operation and cooling.
Outlines the steps for installing the switch.
Instructions for connecting and configuring the switch using its default IP address.
Provides common problems and their solutions for quick diagnosis.
Explains how to interpret LED patterns for troubleshooting switch issues.
Guides on how to reset the switch to its original factory configuration.
To Next Page
