What to do if the Aruba JL683A link light does not light when a cable is connected?
If the link light on your Aruba Switch doesn't illuminate after connecting a cable, begin by checking for loose or visibly damaged connections. Ensure all connections are secure. If the issue persists, try using a different cable.
General| Product Number | JL683A |
|---|---|
| Device Type | Switch |
| Product Series | Aruba 2930F |
| Power over Ethernet (PoE) | Yes |
| PoE Budget | 370W |
| Switching Capacity | 176 Gbps |
| Input Voltage | 100-240 VAC |
| Power Supply | Internal |
| Memory | 512 MB |
| Flash Memory | 256 MB |
| Layer | Layer 2+ |
| Mounting | Rack-mountable |
| Operating Temperature | 0 to 40 °C |
| Management | CLI, Web GUI, SNMP |
| MAC Address Table Size | 16K |
| Jumbo Frame Support | Yes |
| Operating Humidity | 10% to 90% non-condensing |
Describes the Power over Ethernet functionality and power delivery for 1930 switch models.
Precautions to avoid personal injury and product damage during the installation process.
Checks if the switch powers on correctly and completes its diagnostic self-test.
Instructions for mounting the switch in a standard 19-inch rack or equipment cabinet.
Guidance on how to securely mount the switch onto a wall surface.
Steps for placing and securing the switch on a flat horizontal surface or table.
Steps to access and configure the switch via its web browser interface.
Instructions for connecting and configuring the switch using its default IP address if DHCP is unavailable.
Guides on interpreting LED patterns to diagnose switch operational and PoE problems.
Steps to reset the switch to its original factory default configuration.
To Next Page
