AsantéTalk Ethernet to LocalTalk Converter
14
Q: During the boot process of the computer (when connected
directly to the AsantéTalk), the green LED labeled “LI” (Link Integ-
rity) on the AsantéTalk will flash repeatedly. What causes this?
A: The AsantéTalk is attempting to auto-negotiate with the com-
puter. AsantéTalk does not support Ethernet auto-negotiation. Al-
ways power up the AsantéTalk BEFORE booting the computer.
LocalTalk Network Topology
Q: Will every printer with a Mini din-8 connector (round) work with
the AsantéTalk?
A: No. Only LocalTalk capable printers will work, even though they
have a similar connector.
Q: Can I use the AsantéTalk serial cable on an AppleTalk compati-
ble printer?
A: No. The AsantéTalk serial cable connector is designed for serial
printers and for connecting a LocalTalk computer to the AsantéTalk.
It was not designed to establish a LocalTalk network, nor was it de-
signed to communicate with a printer that supports the AppleTalk
protocol.
Q: What cabling should I use to connect my AppleTalk printer to the
AsantéTalk?
A: LocalTalk connector kits are available for building a LocalTalk
network. One connector must be provided for each LocalTalk de-
vice. If a single printer should be attached to a computer, for exam-
ple, two LocalTalk connectors would need to be provided; one for
the AsantéTalk, and one for the AppleTalk printer.
Q: What is the difference between LocalTalk and AppleTalk?
A: LocalTalk topology refers to the physical cabling used to connect
the network devices. AppleTalk protocol compatibility refers to the
software language the devices (computers and printers) use to
communicate with each other.
Q: Is LocalTalk topology different from Ethernet topology?
A: Yes. LocalTalk topology employs a “bus” or “daisy chain” wiring
To Next Page
Loading...
