User’s Manual
31
If these steps do not work, continue with the following:
11. Power down the AsantéTalk and remove the printer cable.
12. Power up the AsantéTalk.
13. While the TX light is flashing, attach the printer cable back into
the AsantéTalk.
14. After waiting 1 minute, re-attach your cable or DSL modem (if
used) to the hub.
These procedures ought to resolve this problem and it is recom-
mended that you now leave the AsantéTalk powered up to avoid
having to reconfigure its set up. If the printer still does not show up,
please contact Asanté technical support at www.asante.com/
support.
To Next Page
Loading...
