TD 92685EN
28 June 2012 / Ver. A
Troubleshooting Guide
Ascom i62 VoWiFi Handset
66
Appendix B: Handset
B.3 Admin Menu Information
Device Info
See section 5.1 Handset Device Information on pa
ge 33.
Site Survey Tool
See section 5.2 Site Survey Tool on pa
ge 33.
Network Setup
Note: The Network Setup function should only be used to check set
tings and modify
parameter values while troubleshooting problems. It should not be used as the main
method for setting up and configuring handsets. The PDM is provided for this purpose.
Option Remark
Network name Allows a user friendly name for the current Network profile use
d in the
handset. The network name is not the SSID but it can be set to
correspond to it.
IP addresses The default IP address set by DHCP. However, a static IP address may be
entered ma
nually. If using a static IP address, the following parameters
can be set:
- Phone IP
- Subnet mask
- Default gateway
- Primary DNS IP-address
- TFTP server IP address
SSID Specifies the SSID setup in the WLAN.
Note: En
tering a SSID with a complex combination of alphanumeric
characters may not easy from
the keypad. The PDM provides an
alternative means of entering the SSID by selecting Network >
<network id> > SSID.
Tip: Th
e SSID is also sh
own in Device info> WLAN info, as long as the
handset is associated with an AP.
802.11 protocol Configures the radio settings (802.11 b/g, 802.11 b/g/n, 802.11a or
802.11a/n.
Security mode Configures the various encryption and authenti
cati
on schemes:
- Open (Default setting in handset with no security)
- WEP (64 or 128 bits)
- WPA-PSK/WPA2-PSK (If both are supported by the AP the handset
sel
e
cts the stronger WPA2.)
To Next Page
Loading...
