ascon G2 Series User Manual

16
4 - Operation
4.2 CONFIGURATION PROCEDURE
Conf
Inp.
sC.dd
sc.lo
sc.Hi
sqr
CHar
Conf
rs.p.C
rs.In
C.pas
275.8 Menu
Unit
Inp
s.p.tM
s.p.
33
274.8 Conf
OK
é0=10
é 0
é 0
é9999
éno
éno
énone
éLoc
é4=20
éP:Sec
Input type
see table 1
N° of decimals
(linear input only)
0 / 1 / 2 / 3
Low range
(linear input only)
from min range up to
sc.Hi
High range
(linear input only)
from
sc.lo to max
range
Square root
(linear input only)
no / yes
Linear inputs
characterisation
no / yes
Engineering Units
see table 2
Inputs
Configuration
Operator
Mode
Press the key until
YES
Enter the configuration
password
NO
Configuration
menu
Setpoint
Configuration
Setpoint selection
see Table 3
Remote Setpoint input
(remote input only)
see Table 4
Time units
and Setpoint slope
p.sec/ p.Min / .phr
Back to the
1st parameter
inp.=Conf
Back to the
1st parameter
s.p.=Conf
If the entered password
corresponds to the value set in
the parameter C.pas at pag. 27,
proceed to YES
from -999 to 9999
(33 as default from the factory)
If the configured hardware option is not installed, the display shows an
hardware error message
H.Err
100
100
Analog output not installed
101
Current trasformer not installed
102
Remote Setpoint input not installed
103
Potentiometer input not installed
104
Analogue output + Remote Setpoint not installed
M5 UK•ed4 10-12-2004 16:20 Pagina 16

ascon G2 Series Specifications

General

Brand	ascon
Model	G2 Series
Category	Controller
Language	English