Ubiquity Router family - User’s guide
This input works as “Connection mode”, also referred as “selector key” in-
put.
By default the status of this input is ignored. When the Ubiquity Router
device is configured to handle the input (see “General options” in the
Ubiquity Router device configuration chapter) it can be used to control
from outside the connection to the server. The input can be driven by a
mechanical selector, by a key selector or by a PLC outputs.
This input allows controlling the device restart from outside. The operation
corresponds to the RESET button. Once the command is received a proper
feedback is returned by the status LED.
The output turns active when Ubiquity Router device is connected to the
associated Domain. Note that the simple connection to the server does not
activate the output, it is required that Ubiquity is successfully authenticat-
ed to the Domain.
The output is active when at least one Control Center client is connected
to the Ubiquity Router device.
Full stainless steel enclosure
To Next Page
Loading...
Need help?
General
