ASSEMBLY
You need a screw driver and hammer.
NOTE: Please read finishing instructions before assembling.
1 Rub Candle wax or soap on the screws.
2 Attach the feet to the base with screws. Not too tight!
3 Twist feet parallel to base. Glue the spacer dowel between the 2 uprights, then immediately glue
uprights in place and secure with screws on the back side of the loom.
4 Glue the 11 pegs into the holes. Tap firmly with a hammer.
5 Secure the tension block in place with bolt, washer and wing nut. Note: tap the head of the bolt
into the wood.
6 Wait 24 hours for the glue to set hard.
7 Insert the small screw and washer into the pilot hole in the front of the base. Use this to hold
the warp thread when warping.
screwwarp starter
screw and
washer
screw
uprights
spacer
washer
wingnut
tension block
tap head of
bolt in
peg
WARPING THE LOOM
Wrap the warp thread around the
handy warp starter.
Round 1
Take the thread around the pegs
as shown. The thread goes up
over the top peg and around the
tension block.
Start here and
change colours here
Tension block in this position to start
LONG WARP
SHORT WARP
Round 1
To Next Page
Loading...
