GET READY TO WEAVE
Open out the feet so the loom stands upright.
Clamp the loom to the table.
SHUTTLE
WIND the weft thread onto the shuttle. Usually
the weft thread is the same colour as the edge
threads.
TIGHTEN THE WARP BY ADJUSTING THE
TENSION BLOCK.
WEAVING
Make Shed 1. Pass the shuttle into the space
between the threads. Pull the shuttle down
towards the front peg almost against the
knots. Pull the shuttle out of the space. Leave
about 10cm of weft thread hanging out.
SHED 1 SHED 2
Weft thread hanging out
To Next Page
Loading...
