10
14. Slide 5 treadles J onto the long steel rod with a round wooden
spacers k between. Add the centre block. Then add the next 5
treadles and round wooden spacers followed by the treadle blocks l
at either end. Note that the rod holes in the treadle blocks must be
towards the top. Then bolt all 3 blocks to BX with M6 x 70 Cup Head
Bolt, M6 X 16 Washer, and M6 Hex Nut.
15. Tap a M6 x 50 Cup Head Bolt through
the inside of back upright CX and then
attach spacer P through the hole with
a M6 x 22 Washer and nylon knob. Note
the middle slot is used to hold the back
beam in the closed position. Repeat for
the other side.
16. Tap a M6 x 50 Cup Head Bolt through the
inside of castle side EX. Locate the slot
in spacer P onto the bolt and secure
with a M6 x 22 Washer and nylon knob.
Repeat for the other side.
Steel Rod
M6 x 70 Cup
Head Bolt
M6 x 70 Cup
Head Bolt
M6 x 70 Cup
Head Bolt
M6 Hex
Nut
M6 x 16
Washer
M6 x 16
Washer
M6 Hex
Nut
M6 x 70 Cup
Head Bolt
M6 x 50 Cup
Head Bolt
M6 x 50 Cup
Head Bolt
TAP IN WITH
HAMMER
M6 x 22
Washer
M6 x 22
Washer
Nylon Knob
Nylon Knob
To Next Page
Loading...
