2 Getting Started
Warning: Before amplifier installation, ensure that your amplifier is not connected to power
and all control levels are turned down (counterclockwise).
2.1 Proper Cooling
Do not block any of the amplifier ventilation vents. When using an equipment rack, mount the
units directly on top of each other. Do not block rear, front, or side air vents. The side walls of the
rack should be a minimum of one inch (2.5cm) away from the amplifier sides, and the back of the
rack should be open.
2.2 Setup Procedure
1. Use the “Primary” or “Secondary” port and a Cat 5 cable to connect to the ACENet switch.
Do not connect both.
2. Connect the “10/100 Ethernet” port to the ACENet switch.
3. Connect the AC power cord.
The Analog Input Connectors are not used in the ASTi system setup.
Warning: Do not connect or disconnect speakers or ACENet while the amplifier is powered
on.
3
To Next Page
Loading...
Need help?
General
