11
Service and guarantee
For guarantee details, see the
guarantee card.
Guarantee Service
Before calling for service, check to see whether the fault is due
to something that you can put right yourself. See the checklist.
If you do require service, telephone your local ASKO retailer or
the ASKO representative for your country. (See guarantee
card for address and telephone number.)
Drain outlet connection
The machine is supplied with the outlet hose
ready fitted. The hose should be hung over a
suitable sink edge or drain pipe at a height of
50–90 cm above the floor: the lower height is
preferable. Make sure that the hose is not
kinked.
NB! If the hose is extended, the internal
diameter of the coupling must not be less
than 15 mm.
Water supply connection
The water supply connections must be made by
a person having the necessary competence.
Water pressure must be in the range 0.1–1 MPa
(ca 1–10 kp/cm
2
, 10–100 N/cm
2
, 15–142 PSI).
A tap must be fitted in the supply pipe for the
hose.
If a new supply pipe has been installed for the
machine, it should be flushed through thoroughly
in order to remove any particles of dirt which
might otherwise block the strainer in the water
inlet of the machine.
50–90 cm
Shut-off taps
Cold water supply
Hot water supply
Sink
To Next Page
Loading...
