Asko 12605 - Page 7

7
• The Wool program cannot be modified by the option buttons, except for (no spin).
• The main wash water is always cooled by the admission of cold water before pumping out in order
to prevent risk of scalding, shrinking and wrinkling.
• Before starting to spin, the machine checks that the load is evenly distributed in the drum. If not, it
redistributes the load by turning at normal drum speed and then makes another attempt to start
spinning.
7. The machines starts
and works through
the stages shown
below.
. . . and start the program
with the program knob.
Remember – turn the program knob
clockwise only.
If you change your mind . . .
. . . and want a different program:
Turn the program knob and program selector to
the required positions, and choose the
temperature you want
. . . or want to interrupt the program
Turn the program knob to10 to make the machine
pump out. After about two minutes, you can open
the door. If you add more washing and restart the
machine, check that there is detergent left in the
detergent compartment.
The machine finishes
these programs with a
short spin.
Press if you do not
want any spin at all.
The machine stops with
the final rinse water still
in it.
Turn the program knob
to 10 to pump out the
machine. Or you can
turn it to 8 for pumping
out followed by a short
spin. Most garments can
withstand a short,
careful spin.
This program is ideal for small,
slightly soiled loads, which only need
freshening. For best results, use only
1/3 of the normal recommended
dosage of detergent.
Points to note:
Spin
***
**
Appr.
Energi
consump.
kWh
1,1-1,7
0,8-1,5
0,5-0,8
0,5
0,6
0,3
0,3
0,3
0,3
0,6
2 rinsesSpin
3 rinses
Main wash
Automatic operations:
Pre-wash
Programme used for AU Energy
Rating Label Acc. to AS2040, dry
load 4,5 kg
*
Time use figures are based on inlet
cold water 20°C, inlet cold water
60°C.
Energy use figures includes use
of hot water.
*
Water-
con-
sump-tion,
lit.
80
73
73
73
73
39
39
39
36
65