Specifications are subject to change without notice. See installation instructions for additional details.
24
ASKO STACKED LAUNDRY PAIRS
DIMENSIONS
US Metric
Height 67"–69" 1702–1753 mm
Width 23-7/16" 595 mm
Depth 24-7/16" 621 mm
Weight 270–275 lbs 122–125 kg
WARNING! Never stack a washer on top of a dryer!
Any ASKO dryer can be mounted on top of any matching
ASKO washer. Stacking kits are packed inside the dryer. Refer to
the ASKO Dryer Use and Care Guide for stacking instructions.
Every ASKO washer is delivered ready-fitted with a plug and is
intended for connection to an ASKO dryer, which is equipped with
a matching receptacle. When an ASKO washer is connected to the
W6021/W6441 AND T721 CONDENSER DRYER
dryer, use 220 V, 30 Amp single-phase circuit. When the dryer is
on a separate outlet, use 220 V, 15 Amp single-phase circuit. If
the washer is used separately or with another dryer, it must be
on a separate 220 V, 20 Amp single-phase circuit.
When placing a stacked pair next to a wall or cabinet, be sure to
leave 1/2" (12 mm) of space between the washer and the wall or
cabinet.
ASKO condenser dryers can be installed to continuously drain
through a hose attached to the rear of the machine. To ensure
proper drainage, the drain must not be higher than 40" above
the bottom of the dryer.
See page 19 for condensation drain requirements.
See page 29 for stacked cabinet or closet installation
dimensions.
To Next Page
Loading...
Need help?
General
