Specifications are subject to change without notice. See installation instructions for additional details.
29
ASKO LAUNDRY
ASKO’s front panel controls make it possible to install the washers
and dryers under a cabinet or in a closet. Make sure there is a
1/2" (12 mm) minimum clearance between units and between
units and cabinet or wall.
Every ASKO washer is delivered ready-fitted with a plug and is
intended for connection to an ASKO dryer, which is equipped with
a matching receptacle. When an ASKO washer is connected to
the dryer, use 220 V, 30 Amp single-phase circuit. When the dryer
is on a separate outlet, use 220 V, 15 Amp single-phase circuit. If
the washer is used separately or with another dryer, it must be on
a separate 220 V, 20 Amp single-phase circuit.
CUTOUT DIMENSIONS
US Metric
Height 34"–35" 863–889 mm
Width 24-1/2" minimum 622 mm
Depth 25" 635 mm
NOTE: For these installations, a custom countertop may be required.
SINGLE UNIT CABINET INSTALLATIONS
WASHER OPENING
VENTED DRYER OPENING
ASKO vented dryers can be vented from the rear or the left or
right side. The cabinet cutout illustrated below gives the dimensions
for a rear or left exhaust.
See page 18 for venting requirements.
CONDENSER DRYER OPENING
WARNING! To reduce the risk of fire, vented dryers
must be exhausted OUTDOORS or the equivalent.
See page 18 for venting requirements.
Never cover the end of the dryer stub or vent hose with
anything to catch lint, except for a UL-approved vent
basket.
Condenser Dryers
ASKO condenser dryers can be installed to continuously drain
through a hose attached to the rear of the machine. To ensure
proper drainage, the drain must not be higher than 40" above
the bottom of the dryer.
See page 19 for condensation drain requirements.
To Next Page
Loading...
Need help?
General
