15
Press start
The dishwasher will now start. It man-
ages the entire wash automatically.
Ensure that the door is properly closed or
the machine will not start.
The display shows ‘Program started’. If the‘Program started’. If the. If the
door is open or not properly closed, ‘Close‘CloseClose
door’ appers in the display.’ appers in the display. appers in the display.
Changing program
If you want to change program after having
started the machine, press the Start/Stop
button for three seconds. Then select a new
program and press the Start/Stop button.
Make sure there is detergent in the dispens-
er.
Do you want to load more dishes?
Carefully open the door; the machine will
stops automatically, put in the dishes, close
the door and the dishwasher will continue
from where it left off.
If the machine is switched off at the
main switch
(or in the event of a power cut) before the
washing program has been completed, the
interrupted program will continue when the
power comes back on.
Note!
If the power is switched off, or if the door
is open during drying, the program is inter-
rupted.
After dishwashing
Once the machine has finished, it only
draws standby current. Turn off the water
faucet if the machine is not to be used for an
extended period, such as during vacations,
for example.
Drying
For additional drying the door should be
opened 35 mm upon completion of the dry-
ing cycle. For more information refer to the
page marked Performance Information in
these instructions.
Basic Course
To Next Page
Loading...
Need help?
General
