EasyManua.ls Logo

Asko DFI533A - User Manual

Asko DFI533A
41 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
USER MANUAL
Dishwasher
EN
DFI533A

Table of Contents

Questions and Answers

  • B
    Bradley WagnerAug 19, 2025
    Why my Asko Dishwasher does not start?
    • T
      Tara WallsAug 19, 2025
      If your Asko Dishwasher isn't starting, several factors could be at play. Ensure the appliance is correctly plugged into the wall socket and that the fuse or circuit breaker hasn't tripped. Make sure the door is properly closed and that the door lock clicks into place. If you opened the dishwasher mid-cycle, simply close the door and wait for the program to resume. To start the program, press until the display shows "Program started". If the Delayed start option is enabled and you wish to cancel it, press and hold for three seconds.
  • C
    Cindy MezaAug 21, 2025
    How to solve the problem of Asko DFI533A if the dishes are not clean?
    • F
      fwilliamsAug 21, 2025
      If your Asko dishwasher isn't cleaning dishes properly, start by checking that the spray arms can rotate freely and aren't blocked by dishes. Clean the spray arms if the holes or bearings are blocked. Ensure you're using a suitable dishwashing program, like the Intensive program for very dirty dishes, and that you're using the correct detergent dosage based on water hardness. Avoid using old detergent and make sure dishes are loaded correctly, without covering porcelain or placing tall glasses in corners. Also, clean the coarse and fine filters, ensure they're correctly fitted, and verify that the yellow drainage pump stop is in place.
  • E
    Elizabeth EdwardsAug 23, 2025
    How to improve drying in Asko Dishwasher?
    • V
      Valerie WilliamsonAug 25, 2025
      If your Asko dishwasher leaves dishes not dry enough, ensure that the Auto door open option is activated. Make sure you fully load the dishwasher. Check the rinse aid level and increase the dosage if it's too low. If you're using all-in-one detergents with the TAB setting activated, consider switching detergents or deactivating the TAB setting and use salt and separate rinse aid.
  • R
    Robert JacksonAug 26, 2025
    What to do if water remains in Asko Dishwasher after cycle?
    • S
      Samantha HarrisonAug 27, 2025
      If water remains in your Asko dishwasher after a cycle, start by cleaning the coarse and fine filters and ensuring they are correctly fitted. Then, clean the drainage pump and check that the yellow drainage pump stop is in place. Inspect the drainage hose for kinks and ensure it is not blocked, maintaining an inner diameter of at least 14 mm at the sink unit's water trap connection.
  • J
    Jonathan GarciaAug 28, 2025
    What to do if my Asko Dishwasher leaves spots or films on the dishes?
    • N
      nclarkeAug 28, 2025
      To address spots or films on dishes washed in your Asko dishwasher, begin by checking the rinse aid dosage setting. If you're using all-in-one detergent and have the TAB setting activated, consider switching detergents or deactivating the TAB setting while adding salt and separate rinse aid. Ensure the salt compartment is full and that your water softener setting is correct. Verify that the salt compartment lid is properly tightened to prevent leaks. If washing crystal, use a lower temperature and less detergent to prevent etching.
  • C
    Christopher RobertsAug 30, 2025
    How to get rid of bad odour in Asko DFI533A?
    • J
      Jasmine CoxAug 30, 2025
      To eliminate a bad odour from your Asko dishwasher, clean around the seals and in the corners with a washing-up brush and a low-foaming cleaner. If you frequently use low-temperature programs, run a high-temperature program or a self-cleaning program once or twice a month.
  • W
    william65Sep 2, 2025
    How to remove grease deposits in Asko DFI533A?
    • J
      jacksonronaldSep 2, 2025
      If you find grease deposits in your Asko dishwasher, try selecting a program with a high temperature, such as the Intensive program, to dissolve the grease. Alternatively, run a self-cleaning program once or twice a month.
  • Y
    ymooreSep 4, 2025
    How to prevent spots on stainless steel or silver in Asko DFI533A?
    • J
      joycejamesSep 4, 2025
      To address spots on stainless steel or silver items after washing them in your Asko dishwasher, rinse off foods like mustard, mayonnaise, lemon, vinegar, salt, and dressings from the dishes if you're not starting the dishwasher immediately. Use the Rinse and hold program. Also, separate dishes made from different metals like silver, stainless steel, and aluminum to prevent contact during dishwashing.
  • D
    Donna OnealSep 6, 2025
    Why my Asko DFI533A leaves a sticky white/blue film on the dishes?
    • H
      Heather BrownSep 6, 2025
      If your Asko dishwasher leaves a sticky white or blue film on the dishes, the rinse aid dosage setting is likely too high. Reduce the dosage. If you have very soft water, you may want to dilute the rinse aid 50:50 with water.
  • S
    Shannon PierceSep 8, 2025
    How to remove spots left after washing in Asko DFI533A Dishwasher?
    • D
      Daniel BrownSep 8, 2025
      If your Asko dishwasher leaves spots after washing, especially from lipstick or tea, try using a detergent with a bleaching agent.

Asko DFI533A Specifications

General IconGeneral
CategoryDishwasher
ModelDFI533A
Capacity13 Place Settings
Energy RatingA++
Noise Level44 dB
Drying SystemTurbo Drying
Child LockYes
Water Consumption9.5 L
Delay StartYes, up to 24 hours

Related product manuals