Service manual DW90
29
Menu step/Turn/Push LCD Comments/instructions
Brand
Variant
PROG
U: 1
Variant 1, default setting (Temperature , Drying )
ASKO
U: 2
Variant 1, default setting (Temperature , Drying )
OTHER
U: 3
Variant 3 (Temperature , Drying , Delayed start )
ASKO
U: 4
Variant 3 (Temperature , Drying , Delayed start )
OTHER
U: 5
Variant 5 (Temperature , Drying , Delayed start ,
Time saver , Time program )
ASKO
U: 6
Variant 5 (Temperature , Drying , Delayed start ,
Time saver , Time program )
OTHER
U: 7
Variant 7 (Temperature , Drying , Delayed start ,
Time saver , Time program , Upper/Lower half load )
ASKO
OTHER
START
Region
PROG
EU
Region Europe (as well as China and Japan), default setting
US
Region USA (as well as Taiwan)
AU
Region Australia
START
Fan sequence
PROG
Y: 0
No fan sequence during program. Dries the load.
Y: 1
Fan works in sequence during the wash cycle, not in normal
program, default setting
Y: 2
Fan works in sequence during the wash cycle, even during
normal program
START
ECO
PROG
E: 0
ECO off, default setting
E: 1
ECO on, if machine connected to hot water supply
less electricity used to heat water and program time
shortened.
START
Super rinse
PROG
S: 0
Super rinse off, default setting
S: 1
Super rinse on. Adds two extra rinses.
START
Total reset
PROG
r: 0
No total reset next time T2 is pressed, default setting
r: 1
Total reset next time T2 is pressed. Should be done after
replacing the control unit to reset all the sensors.
START
Service menu
DW90.1 - BRAND ASKO
P R O G
START
STOP
T2
T1
L1
L6
L2
L4L3
L5
D1, I5
D2,D3
DW90.1 - BRAND OTHER
To Next Page
Loading...
Need help?
General
