Service manual DW90
23
Water level DW90
When servicing a DW90 dishwasher it is
important to check the water level in the machine.
This is particularly important when programming
the time-controlled water intake. Too low or
too high water level can cause poor dishwashing
results.
Always allow the machine to take in and drain
the water a few times before checking the
level.
Check the level against the lower spray arm hub
In the event of too low water level, the filter
in the inlet valve must always be checked and
rinsed clean of any sediment.
The inlet hose with a 3/4” connection at
both ends has a filter in the connector outside
the machine that must also be checked and
rinsed clean of any sediment.
In the US the inlet hose has a 3/8”
connection at both ends and no filter in the
connector outside the machine.
Overflow level = 4.7 L (1.24 gallons)
Without spray arm diverter = 3.2 L (0.8 gallons)
(1.5 mm (1/16”) above the level)
With spray arm diverter = 2.95 L (0.7 gallons)
(in line with the level)
Troubleshooting
To Next Page
Loading...
Need help?
General
