13
START TUMBLE DRYING
Press the button.
The text
at the lower edge of the
display indicates that the program has started.
The text field of the display shows the current
stage of the program while it is in progress.
NOTE
If the child lock is on, the button must
be held down for 3 seconds in order for the
program to start. See Chapter 3, Child safety,
for details of how to switch the child lock on
and off.
Remaining drying time
The approximate remaining drying time is esti-
mated within four minutes of the start of the
drying program. Only the time for the Timed
dry program and Air fluff program is indicated
for venting dryers.
The time is shown in hours and minutes (al-
ternating) at the bottom right of the display
together with the
symbol. Note that the
time also includes cooling.
DURING TUMBLE DRYING
Putting in more washing
Open the door and the drum will stop
automatically. To restart: Close the door and
press the button.
Changing program
Press the button for three seconds. The
program will then be zero set and you can choose
a new program.
DRYING PROGRAM ENDED
The text on the bottom edge of the
display indicates that the program has
ended.
If the Anti-crease option is activated, the
drum will rotate every minute for a certain pe-
riod after cooling. The text [“Anti-crease”] is
indicated in the display during this period. The
program can be stopped at any time by opening
the door.
When the program ends:
• Clean the lint filter after each drying opera-
tion, see below. An error message will be dis-
played if the lint filter needs to be cleaned.
• Empty the condensation water container.
WARNING!
Regularly clean the lint filter. If the lint filter
becomes completely clogged the overheat pro-
tection device may trigger. The device must then
be reset to enable the machine to be started,
see Chapter 12, Trouble shooting.
6
5
To Next Page
Loading...
