EasyManua.ls Logo

Asko W6444A - Troubleshooting; Common Operational Issues

Asko W6444A
32 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
20
Troubleshooting
The washer door will not open
1. Check that the main power switch is on.
2. Is there power? Check your home’s fuses
(circuit breakers). The washer door cannot be
opened with the Door opening button (with
the key symbol) if power is o.
If nothing else works, the washer
door can be opened as follows
WARNING!
The door may only be opened
manually if the electric power is
cut and the machine has been
drained of water.
A Select the Spin & Drain program and the
option with the symbol (no spin) to drain
the water from the machine. If this does not
work the machine must be drained manually.
See "Cleaning the trap and the drainage
pump" in the "Care and cleaning" chapter.
B Ensure that the main power switch is turned
o and that the plug has been removed from
the wall socket.
C Take the emergency door opening key (C)
(see gure in the section Dispenser) and
insert it into the slot on the right-hand side
of the washing machine door latch. The key
is attached on the back wall of the detergent
dispenser. Remove the detergent dispenser
from the washing machine and take the door
opening key.
D Push the tool upwards to open the washer
door.
After use, store the emergency door opening
key (C) in the dedicated compartment (B) (see
image in the section Dispenser).
If in the future the washer door does not open
when the wash program has nished, call the
service division.
The machine will not start
1. Is the washer door properly closed? Push it
rmly.
2. Is there power? Check the fuses and residual
current devices (circuit breakers) in the
building.
3. Check that you have not selected Delayed
Start. To cancel Delayed Start, press the
Start/Stop button for three seconds.
After power failure
Press the main power switch to resume the
current program.
Wet washing still in the machine
A small load can under certain circumstances
cause imbalance (see " Imbalance"). Rearrange
the load and start the spin program, or load
more washing and restart the washing program.

Table of Contents

Related product manuals