Asko W6444A - Safety Instructions; General Safety Guidelines; Specific Safety Areas

5
General
• Read the operating instructions and keep
them in a safe place.
• Installation should be carried out by qualied
ASKO technicians.
• The machine should only be used for
washing items as described in these
instructions. It is not intended for dry
cleaning.
• Use only detergent intended for machine
washing!
• Use only detergents and softeners for
machine wash. Manufacturer may not
assume responsibility for any damage and
eventual discolouring of gaskets and plastic
components as a consequence of incorrect
use of bleach and/or colouring agents.
• Never use detergents containing solvents,
since there is a danger of creating toxic
gasses which may damage the machine and
result in ignition or explosion.
• Remove any transport protection devices
before using the machine. See the "Transport
protection" chapter.
• Repairs and maintenance must be carried
out by a qualied professional.
• Damaged mains cables must only be
replaced by a qualied electrician.
• The machine is not designed to be used by
persons (even children) that are physically
or mentally handicapped or lack experience
and knowledge. Such persons must receive
instruction in how to use the machine or be
supervised by a person responsible for their
safety.
• Children must be watched to ensure they do
not play with the machine.
• In the enclosed plastic bag you will nd a tool
for opening the washer door in emergencies.
Installation
See the "Installation" chapter.
Overow guard function
If the machine’s water level rises above the
normal level, the overow guard function begins
to pump water out and shuts o the water intake.
If the water level has not dropped within 60
seconds, the program is terminated.
Transport/Winter storage
If the machine is to be transported or stored in
unheated premises where the temperature can
fall below freezing, do as follows:
• Empty the lter and the drainage pump. See
the "Care and cleaning" chapter.
• Shut o the water to the washing machine,
loosen the supply hose to the intake valve
and let the water run out from the valve and
hose.
• After emptying the pump, a small amount of
water may remain in the machine. This does
not aect quality or damage the machine.
Recycling
This machine is manufactured and labelled
for recycling. In order to prevent injuries, the
machine must be made unusable once the
decision has been taken to dispose of it.
Contact your local authority for information
about where and how your machine can be
recycled correctly.
Safety instructions