27
Installation
The machine can also be connected to the drain
via a spigot connection. In this case the hose
should also be 600-900 mm above the oor. The
internal diameter of the hole should be at least
18 mm.
• Cut the nipple
• Remove burrs from the hole.
See the illustration.
At least 18 mm
Electrical installation
Connect the machine by plugging it into an
earthed wall socket. The electrical wall socket
must be placed outside of the installation area
to be easily accessible.
CAUTION!
If this appliance is supplied from a cord
extensions set or electrical portable outlet
device, the cord extension ser or electrical
portable outlet device must be positioned so
that it is not subject to splashing or ingress of
moisture.
Connection on delivery
The machine is supplied as 1-Phase, 220-230 V,
50-60 Hz, heat output 2000 W and has a 10 A
plug. Any residual current devices must be type
A.
NOTE!
Repairs and maintenance must be carried out
by a qualied professional.
To Next Page
Loading...
