14
Theseinstructionsshouldbefollowedthefirsttimethegrillisignited,andeachtimethegrillrunsoutofpelletsinthehopper.The
auger must be primed to allow pellets to travel through the length of the auger,and fill the fire pot. If notprimed,the igniter
will timeout before the pellets are ignited, and no fire will start. Follow these steps to prime the hopper:
1.
Openthehopperlid.Makesuretherearenoforeignobjectsinthe hopperorblockingtheaugerfeedsystematthebottom.
2.
Remove all cooking components from the interior of the grill. Locate the fire pot in the bottom of the main barrel.
• DO NOT leave your grill unattended while in use.
• DO NOT move grill when in use. Lock wheels in place to stabilize grill.
• DO NOT use water to extinguish flare-ups.
• Ensure grill is on a stable, level surface and all four casters are in firm contact with the ground.
TURNING ON THE GRILL:
-----------------------------------------------------------------------------------
Note: It is recommended to wash the grill grates and smoking racks with warm soapy water before initial
lighting of the grill.
WARNING: Never use heating fuel pellets as they are not safe for cooking.
Turn the grill back on.
NOTE: During the initial loading of the auger tube, it will take several minutes for the pellets to move
fr
om the pellet hopper to the fire pot. You can speed this process up by holding the Prime button.
Control panel warning
Keeping the lid open, turn the control knob to a desired temperature. After a few minutes you should smell
and see smoke. Initial start up will always be very smoky but it will reduce when the fire is fully lit. NOTE:The
igniter turns off after 10 minutes to preserve the life of the component and to save electricity
To Next Page
Loading...
