INSTALACIÓN Y MONTAJE
a
DISHWASHER
UNPACKAGING
INSTALLATION AND FITTING
2
CONNECTION TO THE PLUMBING
The water connection pi-
pe is located on the back
of the dishwasher:
Connect the pipe to
the water inlet, tighten
the connection nut
and make sure it is se-
curely connected to
the appliance.
a
1
UNPACKAGING THE DISHWASHER
Remove the external pro-
tection: plastic film, top
cover, polystyrene base
and corner pieces.
Internal protection: polys-
tyrene wedges for holding
the racks firm.
The specifications label is on the top edge of the interior of the door. This label must never
be removed, since it provides information about the exact model of the dishwasher, required
power supply, serial number and warranty.
IMPORTANT
To Next Page
Loading...
