Aspes LA25P - Fitting Integrated Dishwashers; Installing Integrated Models

English
59
a
b
c
e
g
h
c
d
f
g
FITTING BUILT-IN DISHWASHERS
To install an integrated
model dishwasher:
If the worktop is made
of wood, place the
plastic protection on
it to prevent steam
damage.
Place the front brac-
kets on the dishwas-
her to fit it to the cup-
board.
Position the dishwas-
her in its space and
adjust the height of
the legs as shown in
the POSITIONING
chapter 4.
Using the supplied
brackets, level the
control panel height
with the height of the
kitchen cupboard
drawer.
Put the template in
position and mark the
position of the holes.
Drill with a 2.5 mm
diameter bit and
screw the supports
(curved side up) to
the door.
Take the door door
and fit the supports in
the recesses in the
door. Pull upwards
until it comes into con-
tact with the control
panel and ensure that
it is firmly in place.
b
d
e
a
c
f
g
The maximum and minimum recommended weights for the door cover to be
fitted on the dishwasher are as follows: Maximum: 7.84 kg Minimum: 2.87 kg
IMPORTANT