Aspes LA25P - Page 56

a
b
c
d
e
f
With some models, the
height to which the door
can be panelled can be
adjusted to the same heig-
ht as the kitchen cup-
boards.
Remove the frame
around the door by
unfastening the
screws.
Remove the decor pa-
nel from the dishwas-
her.
Adjust the plate at the
bottom of the dis-
hwasher door to the
height of the kitchen
cupboards.
Place the decor panel
on the door, mark the
required height and
cut accordingly.
Place the decor panel
on the frame and cut
it to the same height
as the decor panel.
Place the panel on the
door, hold the frame
in place and mark the
position of the new ho-
les on the door. Drill
the holes with a 3.25
mm diameter bit (be
careful not to drill too
deep) and screw the
frame into place.
a
b
c
f
d
e