54
SNP Memory (RMP Table) Coverage
Use this item to congure the SNP Memory (RMP Table) Coverage. When [Enabled] is
selected, the ENTIRE system memory is covered.
Conguration options: [Auto] [Disabled] [Enabled] [Custom]
SMEE
e item controls secure memory encryption enable.
Conguration options: [Auto] [Disabled] [Enabled]
Action on BIST Failure
e item allows you to select the action to take when a CCD BIST failure is detected.
Conguration options: [Auto] [Do nothing] [Down-CCD]
DF Common Options
Press [Enter] to congure DF Common options.
Memory Addressing
Press [Enter] to congure Memory Addressing options.
Memory interleaving
e item allows for disabling memory channel interleaving.
Memory interleaving size
e item contorls the memory interleaving size. e valid values are AUTO, 256 bytes, 1
Kbytes or 2Kbytes. is determines the starting address of the interleave (bit 8, 9, 10 or 11).
DRAM map inversion
Inverting the map will cause the highest memory channels to get assigned the lowest
addresses in the system.
Location of private memory regions
e item controls whether or not the private memory regions (PSP, SMU and CC6) are
at the top of DRAM, at the top of 1
st
DRAM pair or distributed. Note that distributed
requires memory on all dies. Note that it will always be at the top of DRAM if some dies
don't have memory regardless of this option's setting.
Conguration options: [Auto] [Distributed] [Consolidated] [Consolidated to 1st DRAM
pair]
Disable DF to external downstram IP Sync Flood Propagation
e item allows you to disable Error propagation to UMC or any downstream slaves eg.
ECH. Use this to avoid reset in failure scenario.
Disable DF sync ood propagation
e item allows you to disable propagation from PIE to other DF components and
eventually to SDP ports.
Conguration options: [Auto] [Sync ood disabled] [Sync ood enabled]
To Next Page
Loading...
