22
Configuration using the
1385
DIP switch networked stand-alone
1 Address off
2 on
3
Profile number
4
5 off
6 off
7 off
8 Networked operating
mode
= on
Stand-alone operating
mode
= off
Note: A TS bus controller is
required.
The
1385
must be set to
master operation (
1385
:
DIP 3 = on)
Note
If configuration is carried out using
FT Manager
, always select Profile '0'
(called functions templates in
FT Manager
) as it is the only place where
changes can be saved.
Profiles when using the
1385
(stand-alone)
Profile DIP switch Function
3 4
0 off off Link to higher level systems (fac-
tory setting)
1 off on Door operator
2 on off Door control
3 on on Interlock
To Next Page
Loading...