EN14846 -X8E----- (850C,851C,840C,841C) 0402-CPR-SC0155-14 CE
EN14846 3 X 8 E 0 L 7 1 3 (850C,851C) SC0860-14 Performance
EN14846 3 X 8 E 0 L 5 1 3 (840C,841C) SC0173-15 Performance
EN 50130-4 4P03456-E6 (841C-35,851C-35)
4P03456-E7 (84XC-50,85XC-50)
EMC
EN1634:1 E90 4P01152 Fire
SFF3522-1093 Class 4/Class 5
Class 4 and Class5
To meet the Class 4 and Class 5, the following requirements must be met.
For Class 4 and Class 5 requires that the controller is installed in a protected space
with at least grade 3 locking. DAC564 controller must be installed in the SSF 3522
mode.
SSF 3522 Mode
To install a motor lock SSF 3522 mode you should do this:
1
Initiate lock case.
2
Turn off the power.
3
Dip switch 3,7 & 8 in the On position.
4
Turn on the power.
In 3522 the SSF mode will relay then have the following characteristics:
Relay ”Lock” Lock indicator, active for 15 seconds at locked.
Relay ”Alarm” Unlocked indication active for 60 seconds when unlocked.
Relay1 RC64 (Security locked) door closed and deadbolt out.
Relay2 RC64 (Unlocked) deadbolt inside.
Relay3 RC64 (Unlocked, with delay).
Relä4 RC64 (Closed Door).
Relä5 RC64 (Summer, Forced door).
Relä5 RC64 (Summer, Forced door).
RELAY6 RC64 (Tamper) Relay energized in alarm, the alarm must be installed.
Accessories SSF 3522
All components belonging to the locking device (such as lock cases, striking plates
and Door reinforcement) shall have the same classification according to SSF 3522.
.
9
To Next Page
Loading...
Need help?
General
