Security lock fitting with integrated access control
Page 48 D0047105
3 Reset
The fitting is put back into installation mode.
Beware
Access by unauthorised persons is possible! There is a security leak.
Program the Master-Code at once.
If you leave the fitting in the original installation mode, it can be activated with pressing 0 (zero).
If you reset the system:
all User-Codes are cancelled.
the Master-Code is 0 (zero).
the security fitting is activated.
Reset
Dismantle the interior fitting. You will find a detailed description from
the assembly instructions for the fitting.
The flat ribbon cable must be activated.
All batteries must be inserted and functional.
Press the reset tester and hold down for 4 – 6 seconds
(not longer!).
After let go the reset tester, the fitting should deactivate and the
green LED (
) should flash several times.
Assemble the fitting. You will find a detailed description from the
assembly instructions for the fitting.
Remark: Shall the fitting doesn´t react despite of several
attempts
with variation of the time window (4 to 6 seconds),
then:
Remove batteries.
Wake up Anykey security fitting (Press any key).
Put batteries back in.
Repeat that procedure.
Assemble the fitting.
Das Bild kann nicht angezeigt werden. Dieser Computer verfügt möglicherweise über zu wenig
Arbeitsspeicher, um das Bild zu öffnen, oder das Bild ist beschädigt. Starten Sie den Computer
neu, und öffnen Sie dann erneut die Datei. Wenn weiterhin das rote x angezeigt wird, müssen
Sie das Bild möglicherweise löschen und dann erneut einfügen.
To Next Page
Loading...
