1
Measure and mark holes, using dimensions shown below
Left hand shown; Right hand opposite
(See page 4 for additional details)
With provided fasteners, secure closer body to door
with power adjustment facing away from hinge
Prepare Holes
1
3
2
OR
Pre-drill - 3/32" holes for self tapping screws
or #16 drill for #12-24 tap for machine screws
(Use 1/8" hole for fire rated wood doors)
A7347B
Copyright
©
SARGENT Manufacturing. All rights reserved.
Reproduction in whole or in part without the express written
permission of SARGENT Manufacturing is prohibited.
351 WITH OT,OTB,HT,HTB ARM AND TRACK
INSTALLATION INSTRUCTIONS (PULL SIDE)
CAUTION: FAILURE TO INSTALL OR ADJUST PROPERLY MAY RESULT IN INJURY OR DAMAGE
FOR INSTALLATION ASSISTANCE CALL SARGENT AT 1-800-727-5477 • www.sargentlock.com
NOTE: AN AUXILIARY DOOR STOP IS REQUIRED
4
A7347B
Copyright
©
SARGENT Manufacturing. All rights reserved.
Reproduction in whole or in part without the express written
permission of SARGENT Manufacturing is prohibited.
To Next Page
Need help?
General
