What does 'low ambient temperature protection' mean for my Astralpool PROELYXP11i Heat Pump?
The 'low ambient temperature protection' message on your Astralpool Heat Pump indicates that the unit is either being used outside of its intended environment or that there is a sensor abnormality. Stop using the unit if it is beyond its operating scope, or change the sensor.
What causes piping temperature too high protection under cooling mode T3 in Astralpool PROELYXP11i?
Piping temperature too high protection under cooling mode T3 in your Astralpool Heat Pump can be caused by a high ambient or water temperature, or an abnormal refrigeration system. Check the scope of using and the refrigeration system.
What to do if my Astralpool Heat Pump displays IPM module protection?
If your Astralpool Heat Pump displays an IPM module protection error, it could be due to a data mistake, wrong compressor phase connection, compressor liquid and oil accumulation, or a damaged compressor or driver board. You can try turning off the electricity supply and restarting after 3 minutes, changing the driver board, or checking the compressor sequence connection.
What does 'VDC voltage too low protection' mean for my Astralpool PROELYXP11i?
The 'VDC voltage too low protection' error in your Astralpool Heat Pump indicates that the line voltage is too low or the driver board is damaged. Check if the power is in the normal range or change the driver board.
What causes input current over high protection in my Astralpool Heat Pump?
Input current over high protection in your Astralpool Heat Pump can be caused by a large momentary compressor current, abnormal water flow, power fluctuations, or an incorrect PFC inductor. Try checking the compressor, the waterway system, the power range, and if the correct PFC inductor is used.
How to troubleshoot IPM module thermal circuit abnormality in Astralpool PROELYXP11i Heat Pump?
An abnormal IPM module thermal circuit in your Astralpool Heat Pump can be caused by an output abnormality of the IPM module thermal circuit or a problem with the fan motor (abnormal or damaged) or a broken fan blade. Try changing the driver board, checking if the motor speed is too low or fan motor is damaged, or changing the fan blade.
What to do if my Astralpool PROELYXP11i shows IPM module temperature too high protection?
If your Astralpool Heat Pump displays an IPM module temperature too high protection error, it could be due to an output exception of the IPM module thermal circuit, an abnormal or damaged motor, or a broken fan blade. Try changing the driver board, checking if the fan motor speed is too low or fan motor is damaged, or changing the fan blade.
Overview of technical specifications.
General technical parameters of the heat pump.
Guidelines for placing the unit outdoors.
Steps for the first start-up of the unit.
Wiring diagram for models 71676-71680.
Wiring diagram for model 71681.
Wiring diagram for models 71682/71683.
Wiring diagram for model 68822.
Wiring diagram for models 68821/68823.
Guidelines for electrical installation and safety.
Explanation of buttons and their functions.
Logic table for heating operation.
Logic table for cooling operation.
Lists error codes and their solutions.
Explains specific protection functions.
Troubleshooting for issues without error codes.
General| Brand | Astralpool |
|---|---|
| Model | PROELYXP11i |
| Category | Heat Pump |
| Language | English |
To Next Page