10
© 2016 Directed. All rights reserved.
Remote and System Operations
These Remote and System Operations are only applicable to 2625-TX
remote control.
Out of Range
Each time a command is performed the 2625-TX will expect a
command confirmation from the system. If a command confirmation is
not received, the transmit LED turns solid ON for a few seconds and
a long beep plays as an alert.
No Remote Output
Occasionally when a command is performed the remote may not
generate a command confirmation output or Out of Range output.
This indicates that the system received the command but it was an
incomplete command (e.g. TRUNK button pressed too short to activate
the trunk release) or it was an illegal message (e.g. the command was
corrupted due to local RF interference). These are temporary normal
functions of the system and remote, perform the command again
within 10 seconds to return to normal operation.
To Next Page
Loading...
Need help?
General
