15
© 2017 Directed. All rights reserved.
• Combo Valet ( x4 + )
The Combo Valet command is used to turn on/off both Alarm Valet and
Start Valet together.
- If both Valets are off then both will be turned on.
- If one or both Valets are on, then they will be turned off.
The 2-way remote control confirms by using text, icon, or tones.
• Manual Valet Modes
Use the following routine to manually turn on/off the Valet Modes, turning
both on manually achieves Combo Valet:
Turn the ignition ON and then OFF.
For Alarm Valet:
1. Press and release the Valet button once.
2. Alarm Valet will turn on/off accordingly. The Control Center LED will
be on while Alarm Valet is on and will be off when Alarm Valet is off.
The siren/horn also sounds to confirm.
For Start Valet:
1. Press and hold the Valet button for five seconds.
2. The parking lights flash nine times in rapid succession when turned
on, and nine times in slow succession when turned off. The 2-way
remote control confirms by using text, icon, or tones.
Emergency Override
The following procedure Disarms the system when a programmed remote is not
available. Number of presses__________
1. Turn the ignition ON.
2. Press the Valet button the correct number of times (the default is one press).
After a few seconds the siren output ceases and the system is Disarmed.
To Next Page
Loading...
