AstroStart DSP625 User Manual

9
© 2017 Directed. All rights reserved.
Remote Start
Press and release
Activates the remote starter. The engine and parking lights turn On and the
Remote start LED and On tones play, or the engine and parking lights turn
Off and the Remote start LED and Off tones play to confirm. If a Remote start
configuration issue prevents the engine from starting, a fault tone plays while the
parking lights flash to identify the fault.
Press and hold
for at least 4 seconds to remotely stop the engine.
Alert Conditions:
Parking Light Flashes Possible Cause Solution
5 Brake ON Release Foot Brake.
6 Hood Open Close Hood.
7
After performing Remote Start
command MTS not enabled.
Enabled MTS Mode.
9 Start Valet on Turn Start Valet off
Valet Modes
Remote Valet Modes. The Valet commands in the remote command table turn
on/off the Alarm Valet, Start Valet, or Combo Valet Modes (both Alarm & Start
Valet).
• Alarm Valet ( + )
The Alarm Valet mode will disable included alarm features when armed/
locked. It also disables any passive arm/lock settings if programmed on.
The 2-way remote control confirms by using LED and tones.
• Start Valet ( + )
The Start Valet mode will disable remote start features until turned off. The
2-way remote control confirms by using LED and tones.

AstroStart DSP625 Specifications

General

Brand	AstroStart
Model	DSP625
Category	Remote Starter
Language	English