Asus DSL-N10 User Manual

16
DSL-N10 Chapter 3: Conguring the clients
3
Conguring the
network clients
Accessing the wireless ADSL router
Setting an IP address for wired or wireless clients
To access the ASUS Wireless ADSL Router, you must have the correct TCP/IP
settings on your wired or wireless clients. Ensure that the clients’ IP addresses are
within the same subnet as the ASUS Wireless ADSL Router.
By default, the ASUS Wireless ADSL Router integrates the DHCP server function,
which automatically assigns IP addresses to the clients in your network.
But in some instances, you may want to manually assign static IP addresses on
some of the clients or computers in your network rather than automatically getting
IP addresses from your wireless router.
Follow the instructions below that correspond to the operating system installed on
your client or computer.
Note: In the Router mode, if you want to manually assign an IP address to your client, we
recommend that you use the following settings:
• IP address: 192.168.1.xxx (xxx can be any number between 2 and 254. Ensure that the IP
address is not used by another device)
• Subnet Mask: 255.255.255.0 (same as the ASUS Wireless ADSL Router)
• Gateway: 192.168.1.1 (IP address of the ASUS Wireless ADSL Router)
• DNS: 192.168.1.1 (ASUS Wireless ADSL Router) or assign a known DNS server in your
network

Asus DSL-N10 Specifications

General

Ethernet LAN	Yes
Cabling technology	10/100Base-T(X)
Networking standards	IEEE 802.11b, IEEE 802.11g, IEEE 802.11n, IEEE 802.3, IEEE 802.3u
Receiver sensitivity	-95dBm@1Mbps, -92dBm@11Mbps, -75dBm@54Mbps, -72dBm@72.2Mbps, -68dBm@150Mbps
Ethernet LAN data rates	10, 100 Mbit/s
Ethernet LAN interface type	Fast Ethernet
Bandwidth	2.4 GHz
Input voltage	100 - 240 V
Input frequency	50/60 Hz
Dimensions (WxDxH)	164 x 116.5 x 31 mm
Power requirements	DC 12 V/1 A
Channels quantity	13 channels
DSL specification	ADSL 2/2+
DHCP client	-
Transmit power	17 dBmW
Antennas quantity	1
Antenna gain level (max)	5 dBi
Ethernet LAN (RJ-45) ports	4
Security algorithms	128-bit WEP, 64-bit WEP, 802.1x RADIUS, WPA, WPA-PSK, WPA2, WPA2-PSK
Authentication method	Radius
Flash memory	1 MB
Certification	CE, FCC, A-Tick, IC, CT
Internal memory	2 MB
Power consumption (typical)	12 W
Storage temperature (T-T)	-40 - 60 °C
Operating temperature (T-T)	-10 - 50 °C
Operating relative humidity (H-H)	5 - 95 %
Cables included	LAN (RJ-45), Phone (RJ-11)
Product color	Black
LED indicators	DSL, LAN, Power, Status, WLAN

Weight and Dimensions

Weight	255 g