Asus H97I-PLUS - Page 74

PS/2 Keyboard and Mouse Support [Auto]
SelectanyofthesesettingswhenPS/2keyboardandmouseareinstalled.Thesesettings
onlyapplywhenFastBootisenabled.
[Auto] ForafasterPOSTtime,PS/2deviceswillonlybeavailablewhenthe
systembootsuporrebootedwhenthePS/2deviceshavenotbeen
reconnectedorchanged.IfyoudisconnectorchangePS/2devicesbefore
restartingthesystem,PS/2deviceswillnotbeavailableandBIOSsetup
programwillnotbeaccessibleviaPS/2devices.
[FullInitialization]Forfullsystemcontrol,PS/2deviceswillbeavailableduringPOSTatany
circumstances.ThisprocesswillextendPOSTtime.
[Disabled] ForthefastestPOSTtime,allPS/2deviceswillnotbeavailableuntilyour
computerenterstheoperatingsystem.
Network Stack Driver Support [Disabled]
[Disabled] SelecttoskipthenetworkstackdriverfromloadingduringPOST.
[Enabled] SelecttoloadthenetworkstackdriverduringPOST.
Next Boot after AC Power Loss [Normal Boot]
[NormalBoot] ReturnstonormalbootonthenextbootafterACpowerloss.
[FastBoot] AcceleratesthebootspeedonthenextbootafterACpowerloss.
2.8.2 Boot Logo Display [Auto]
[Auto] AdjustslogoautomaticallybasedonWindows
®
displayrequrements.
[FullScreen] Maximizethebootlogosize.
[Disabled] HidethelogoduringPOST.
POST Delay Time [3 sec]
ThisitemappearsonlywhenyousetBootLogoDisplayto[Auto]and[FullScreen].Thisitem
allowsyoutoselectthedesiredadditionalPOSTwaitingtimetoeasilyentertheBIOSsetup.
YoucanonlyexecutethePOSTdelaytimeduringNormalBoot.Thevaluesrangefrom0to
10seconds.
Thisfeaturewillonlyworkundernormalboot.
Post Report [5 sec]
ThisitemappearsonlywhenyousetBootLogoDisplayto[Disabled].Thisitemallowsyouto
selectadesiredpostreportwaitingtime.Congurationoptions:[1sec]~[10sec][UntilPress
ESC].
2.8.3 Bootup NumLock State [Enabled]
Thisitemallowsyoutoenableordisablepower-onstateoftheNumLock.Conguration
options:[Disabled][Enabled]
2.8.4 Wait for ‘F1’ If Error [Enabled]
Whenthisitemissetto[Enabled],thesystemwaitsfortheF1keytobepressedwhenerror
occurs.Congurationoptions:[Disabled][Enabled]
2-42
Chapter 2: Getting started