3-8
Chapter 3: General Instructions
Accessories
DP cable, HDMI cable, USB cable, power
adapter, power cord, Driver and Manual disc,
Quick start guide, warranty card, LED projection
coverandchangeablefilms,Input/Outputport
cover
Compliance and Standards
CB,CE,CU,CCC,UL/cUL,FCC,RCM,BSMI,
VCCI, RoHS, WEEE, J-MOSS, ErP, PSE,
CELLevel1,Windows7WHQL,Windows8.1
WHQL, Windows 10 WHQL, KCC, E-Standby,
TUV-Flicker Free, TUV-Low Blue Light
*Specifications are subject to change without notice.
3.4 Troubleshooting (FAQ)
Problem Possible Solution
Power LED is not ON Press the power button to check if the •
monitor is in the ON mode.
Check if the power cord is properly •
connected to the monitor and the power
outlet.
The power LED lights white and there is no
screen image
Check if the monitor and the computer are •
in the ON mode.
Make sure the signal cable is properly •
connected the monitor and the computer.
Inspect the signal cable and make sure •
none of the pins are bent.
Connect the computer with another •
available monitor to check if the computer
is properly working.
Screen image is too light or dark Adjust the Contrast and Brightness •
settings via OSD.
Screen image bounces or a wave pattern is
present in the image
Make sure the signal cable is properly •
connected to the monitor and the
computer.
Move electrical devices that may cause •
electrical interference.
Screen image has color defects (white does
not look white)
Inspect the signal cable and make sure •
that none of the pins are bent.
Perform All Reset via OSD.•
AdjusttheR/G/Bcolorsettingsorselect•
the Color Temperature via OSD.
To Next Page
Loading...
Need help?
General